TEKRAM TECHNOLOGY CO., LTD.

DC-690B

  Data bus:                32-bit, PCI

  Size:                    Three/quarter-length, full-height card

  Hard drive supported:    Four IDE (AT) Interface drives

  Floppy drives            None
  supported:

[Image]

                            CONNECTIONS

                   Function                          Location

  40-pin IDE (AT) Interface connector - IDE-0          CN1

  40-pin IDE (AT) Interface connector - IDE-1          CN2

  14-pin PCI legacy-header connector                   CN3

  10-pin cable connector to JP4                        CN4

  2-pin connector - drive active LED                   JP1

  4-pin connector - cache error speaker                JP2

  10-pin cable connector to CN4                        JP4

                          PCI INTERRUPT SELECTION

     INT       JP3/jumper 1   JP3/jumper 2   JP3/jumper 3   JP3/jumper 4

  »   INTA        closed          open           open           open

      INTB         open          closed          open           open

      INTC         open           open          closed          open

      INTD         open           open           open          closed

                        USER CONFIGURABLE SETTINGS

              Function                    Location            Setting

  »   Hard drive port address 1F0h      JP3/jumper 5          closed
      and IRQ14 enabled

      Hard drive port address 170h      JP3/jumper 5           open
      and IRQ15 enabled

  DRIVE ACTIVE LED ERROR CODES (IMMEDIATELY AFTER POWER-UP)

            Status                        Function

        One short flash            No cache DRAM installed

       Two short flashes                  CPU error

      Three short flashes                SRAM error

      Four short flashes                 Timer error

                       MISCELLANEOUS TECHNICAL NOTES

    Some versions of this board have two 512KB x 8 DRAM chips mounted in
   place of Bank 0. In such a case the board will work without additional
    memory. In all other cases a pair of 256KB, 1MB, or 4MB SIMM modules
          must be installed in Bank 0 for the board to function.

    The optional ISA/EISA paddleboard solves the DC-690B incompatibility
    problem with some early PCI mainboards. If installed, connect CN3 to
            JP4, and set JP4/jumpers 1-4 in the open position.